Week 13: (December 11th 1999)

This week was spent finishing up the carbs.   I have tried to show the procedure in the following photographs but I could not have done this rebuild without the official SU shop manual.  A very necessary book for this job:

Parts laid out for assembly.  New butterfly, spindle, jet, needle etc..

New spindle and butterfly installed:

An unfortunate semi-out of focus photo of the float installed:

Float chamber assembled:

Parts for the choke linkage: Notice the non-waxstat linkage:

Close up of the non-waxstat jet & linkage: (linkage assembled)

Jet installed w/linkage

Jet attached to float chamber:

Lifting pin installed:

Suction Chamber installed:

Both carbs rebuilt and laid out:

Carbs temporarily bolted onto manifold: